One switch
away from
unstoppable.
Kill-N-Switch Tech installs hidden, fail-safe ignition interrupts that stop a stolen vehicle from ever leaving the curb — no app required, no signal to jam, nothing for a thief to find.
Built to be found by you. Never by them.
Every install is wired into a factory circuit and hidden away from the usual suspects — steering column, fuse box, OBD-II port. A thief with a scan tool and ten minutes still hits a dead end.
Covert Install
Wired into a factory circuit at a non-obvious point, chosen per vehicle so it's never the same spot twice.
Silent Arming
Toggle a hidden physical switch or discreet fob sequence — no app, no Bluetooth signal to sniff or jam.
Circuit Interrupt
Breaks the starter or fuel circuit the instant the ignition is bypassed. The engine simply never catches.
No Signal, No Failure
Purely electrical, not app-dependent — dead zones, dead phones, and jammers don't touch it.
Three states. One outcome.
The system lives in one of three states at any time — this is what a theft attempt actually looks like from the vehicle's side.
Vehicle is parked
You arm the switch on your way out. The starter circuit is now open. Everything else in the vehicle behaves completely normally.
Someone tries to start it
Key, fob clone, hot-wire, tow — doesn't matter. The circuit stays open. The engine gets power everywhere except the one point that matters.
You start it, normally
Flip the switch back, or run the fob sequence, and the circuit closes. Turn the key. Drive off. No delay, no dashboard warning light.
Installed on what you actually drive.
If it has a starter circuit, we can hide a switch in it. Common installs below — ask about anything not listed.
Co-owned. Hands-on. No subcontractors.
Kill-N-Switch Tech is run by two people, not a call center — Kenneth handles sales, Harold handles every install.
Kenneth Shelton
Kenneth is your first call — he'll walk you through what fits your vehicle, answer questions, and get your install scheduled.
Harold Milota
Harold does every install personally — hidden switch placement, wiring, and testing — so the person who designs the hide is the one who wires it in.
Request an install quote.
Tell us about your vehicle and where you're located. We'll get back to you with pricing and the nearest install slot.